1. TURN YOUR DEVICE OFF AND ENGAGE THE HOLD SWITCH!!!!! Take out the battery if it's removable

2. Wash your hands and clean any fingerprints from your device. Next, in a shallow dish, mix about a thumbnail size drop of mild liquid soap (baby shampoo works best) with about 10 oz. water to make the application solution.

Tip: Let the solution sit for about 10 minutes to allow all the suds and tiny air bubbles to dissipate.

3. Identify the function pieces of the Skin and determine what parts of the device they are applied to.

4. Wet your fingers with the solution and peel the skin from the liner. Dip the skin in the solution to wet the adhesive side thoroughly. Do not lose track of which side of the Skin was stuck to the liner! This is the side that will adhere to the device.

Tip: Keeping your finger tips wet will prevent your fingers from sticking to the adhesive and leaving finger prints on the under side of the skin.

5. Lightly shake excess water from the Skin. It doesn’t need to be dripping wet; a thin film of solution works the best.

6. Slowly lay the Skin onto the device and slide it into position. The Skin should slide freely on the surface of your device at this point. If it doesn’t try adding a little more soap to your water and re-wetting the film.

7. Begin by pressing some of the water out from under the film with your fingers being careful not to move the Skin from it’s place.

8. a credit card (or something similar) to squeegee the water and bubbles out from under the film.

**If you see bubbles you are unable to remove or unhappy with the placement of your Skin, now is the time to remove it and return to step 1. After it has time to set up you will not be able to remove the Skin without stretching it.

9. If you are applying a skin with flaps or areas that won’t stick down, give the Skin about 15-30 minutes for the solution to evaporate. Then wrap the area over and press it down with the palm of your hand for about 30 seconds.

10. After pressing down the last area, we suggest that you let the Skin set up for 24 hours before turning on the device. The look of the Best Skins Ever will improve over the next 24-48 hours as the water evaporates and the adhesive sets up.

Tip: Take the time to remove the scrap from the rest of your Skins you have ordered and store them in the envelope or a zip lock bag. Do Not store any unused skins face to face. They will stick together.

Download PDF instructions here.

We’re always looking for ways to improve our product. If you have any suggestions, please let us hear about them at info@bestskinsever.com

If you’re happy with your purchase, please tell a friend on your favorite message board.

Thank you!

www.BestSkinsEver.com

Go Back